SS7
Click Here to return to the main Screen: Back
The SS7 Menu allows you to setup the SS7 stack, linksets, links and CIC mapping. It also gives you access to the status of the spans and channels of the SS7 gateway. These can be further configured using the Mediant GUI.
Important Note: This will not configure the SS7 on the Mediant gateway itself. This only configures the M3UA driver on Sky Dance. To configure the Audiocodes Mediant SS7, you will need to refer to the GUI for that. Either the Web GUI (M2K/M3K) or the EMS (all Medant gateways)
SS7 Stack
This table defines the Originating Point Code(s) of the gateway. As linksets and links are defined, they can be added back to this table. To edit it, click the checkbox to the left of the row and click edit. To add, click the add button
Note: Before you define linksets, links and CICs, you must have a stack defined
When you click edit, you will be presented with the following screen:
Note that when you first define a stack, you will not have any linksets defined yet. (These can be added later after you define them). So step 1, you will define just the stack. Then go back to the menu and define the linksets, then the links. Then go back through the list - adding links to the linksets and linksets to the stack to complete the job.
SS7 Linkset
This table defines the linksets that connect the Sky Dance SS7 gateway to a carrier.
Note: Before you define links and CICs, you must have a stack and linkset defined
SS7 Route
This table defines the routes that connect the Sky Dance SS7 gateway to a carrier.
Note: Before you define routes and CICs, you must have a stack, linkset and linksdefined
